Although MESH connections have been in use since the second generation of Wi-Fi, it's only with the advent of the 6G 802.11ax standard has a new quality emerged. MESH connections are required for temporary networks or in cases where the cable network cannot be transported to all locations and it is necessary to expand the coverage area in just one part of the room, but the cabling work is complicated. …

Virtual Smartone allows you to perform spectrum analysis of all APs (Troubleshooting menu), regardless of the location of the APs. In addition to spectrum analysis, the client's 802.11 protocol behavior can be diagnosed when it cannot access the network. In addition, WIRESHARK packet streams from both the AP and the tunnels can be stored.

But why is the airtime graph so much better than just looking …

The purpose of IoT is not to bring device control from a traditional shape to a smartphone or Internet browser in the same way - it seems simple, but it is still a copy of the old automation architecture in a cheaper form.

There is also no program or software that can control the system under conditions suitable for all parties, but there is constant development, new ideas and user …

Most standards-compliant wireless IoT devices can be connected to the Ruckus IoT solution. Some devices also have plug-ins for servers that use some vendor-specific features.

3kgroup helps partners do process analytics and systems analysis, and with the help our engineers you have a fully integrated IoT solution of your own.

Managing IoT devices is similar to managing Wi-Fi APs from an IoT server. By pairing the device, the server recognizes …

Problems in Wi-Fi and fixed networks are varied and assessing quality is becoming increasingly difficult as the size of the network grows. For example, when moving over a large area, the quality of the network can vary greatly, as does the load and the amount of interference over time. We have developed a solution that can be implemented quickly and is reliable and transparent.

Our solution is to install stationary …

We wanted to see with our own eyes the effect of the various innovative technologies used in WiFi 6 and how it affects the end-user experience.

We compared WiFi 6 devices with the previous 5th generation WiFi devices. WiFi access points or access points were under testing. We did not change any devices other than APs during the test.

Our test

In our test we used a WiFi 6 (ax …

Before the autumn storms, a 16m high mast was installed in the port of Ruhnu, the mast solution produced by Aerial OY is very light, about 5 Kg/m, and it can be lifted on the hinges with two men. The mast can also be climbed for maintenance.

The same mast solution is also suitable for roofs and for installation at lower heights without wires.

…

Ruckus IoT software provides the ability to connect four wireless standard IoT devices to Ruckus Wi-Fi APs. The standards are BLE, Zigbee, LoRa and of course Wi-Fi.

This week we tested the compatibility between the Zabbix monitoring software and the Ruckus IoT, we recorded the data for a few days from a Zigbee 3.0 sensor.

Zabbix allows alarms and monitoring to be brought to the management of an IT department …

Wi-Fi roaming means moving from one customer's base station to another in the territory and maintaining a connection during the base station switching process. Thus, the term is slightly different in mobile communications, where the same thing is understood as handover, but it is not very critical in mobile communications, because the density of base stations is hundreds of times higher in the mobile communications network.

The history of Wi-Fi …

In January 2020, a new Unleashed software update 200.8 was released.

In addition to the new features described here, some special features are now revealed:

The following 802.11ac Wave1 APs are no longer supported in Unleashed 200.8 and later:

• R310
• R500
• R600
• T300
• T300e
• T301n
• T301s

If there are any fore mentioned APs in the system, an alert will be issued during the …